Bissell 80K6 Carpet Cleaner User Manual


 
www.bissell.com 800.237.7691
Operations
8
Before you clean
Thoroughly sweep or vacuum floor
prior to cleaning with the Steam Mop
Select.
Cleaning hard floors
Your Steam Mop Select is designed to
clean hard flooring such as ceramic
tile, vinyl, laminate, marble, stone and
sealed hard wood floors. Use of your
Steam Mop Select on waxed or some
unwaxed floors may result in a dimin-
ished glossiness. The Steam Mop Select
is not for use on unsealed wood floors.
For best results test in an inconspicu-
ous area and check the care instructions
from your flooring manufacturer.
1. Plug the unit in and wait 30 seconds for it to
heat up. Begin cleaning by slowly passing
over surface while pressing the steam on
demand trigger to emit steam as needed.
2. To sanitize an area of your floor, (attack
invisible germs and bacteria) place the
Steam Mop Select over the spot for a mini-
mum 15 seconds using continuous steam,
but no longer than 20 seconds using contin-
uous steam. For larger areas, overlap swivel
head placement.
3. When the mop pad becomes soiled, simply
flip the mop head over to use the other side
by lifting the Steam Mop Select off the floor.
Lift the device off the floor so the flip head
springs forward. Place the edge of the mop
head on the floor and apply forward or
backward pressure depending on which
side of the pad you wish to use.
NOTE: When cool, the mop head
may not immediately spring for-
ward. While in use, the mop head
will spring forward as directed.
4. When the Steam Mop Select stops emitting
steam, unplug the unit. Simply remove the
water tank, refill, and continue cleaning.
WARNING:
Never put descaling, alcoholic,
or detergent products into the steam
cleaner, as this may damage it or
make it unsafe for use. Only use
BISSELL authorized aromatic
products