Filter
Top Products
www.bissell.com
Maintenance and care
10
The post-motor filter is a H13 HEPA
media filter*, which assists in the
filtration process to return clean air to
the room.
1. Unplug the vacuum from electrical outlet.
2. Remove the filter door, located on the
front of the vacuum.
3. Remove the post motor filter.
4. Replace the post-motor filter with a new
filter.
NOTE: The post-motor filter is a
white pleated HEPA media filter*.
This filter is NOT washable and must
be replaced when it becomes dirty.
5. Replace the door by inserting the tabs on
the left side and snapping the right side into
place.
Maintaining the TurboBrush tool
The TurboBrush tool should be checked
regularly for clogs or debris wrapping
around the brush roll.
1. Remove TurboBrush tool from hose or front
of vacuum.
2. Twist collar so opening is at the top and lift
top cover to remove.
3. Remove brush from belt and clean debris.
4. Replace brush inside belt and place ends
into slots on sides.
5. Reposition top cover, making sure to
line up the inside tab at the front with
the opening on the cover. Twist collar
until opening is at the bottom to lock into
place.
Replacing the HEPA media post-motor filter*
*The Filter Media, not the vacuum as a whole, complies with the High Efficiency
Particulate Air (HEPA) filter specification (EN 1822-1:2009).
HEPA
Media
Post-Motor
Filter*
WARNING:
To reduce the risk of injury
from moving parts, turn the
power switch OFF and
disconnect plug from electrical
outlet.