Filter
Top Products
www.bissell.com 800.237.7691
Assembly
You need: Phillips head screwdriver.
Attach handle to vacuum
1. Locate the vacuum handle and remove
the screw packet (1 screw) taped to the
base of the handle.
2. Stand the vacuum upright and slide
the base of the handle firmly into the
grooves at the top of the vacuum body.
3. IMPORTANT – Continue to push firmly
until the handle is flush with the front of
the vacuum body.
4. Insert the screw provided and tighten
securely.
Attach vacuum hose and tools
1. Attach the Twist ‘n Snap™ hose by lining
up the tabs on the base with the cor-
responding notches on the back of the
vacuum. Turn the Twist ‘n Snap hose to
the right to lock the hose into place.
2. Grasping the Quick Reach
®
handle,
slide the end of the hose wand onto the
hose wand base. Snap the hose into the
hose clip.
NOTE: The Powerfoot will not
suction properly unless the hose
wand is firmly attached.
3. Slide the extension wand and the crevice
tool together into the storage holder.
4. Snap the combination tool into the stor-
age clip.
5. Attach the Pet TurboBrush by aligning the
small holes near the brush roll with the
tabs at the bottom of TurboBrush hous-
ing. Snap TurboBrush into place.
NOTE: 67F8 series includes Pet
TurboEraser™ Tool.
6. Flip the Pet Hair Lifter down until it clicks
into place on the front of the foot.
NOTE: Flip the Pet Hair Lifter down
for carpeted surfaces and up for
non-carpeted surfaces.
5
2.
4.
1.
5.
6.
3.
4.
2.