Filter
Top Products
16
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
11
Maintenance and care
The post-motor HEPA media filter assists in
the filtration process to return clean air to
the room.
1. Turn vacuum OFF ( ). Unplug the vacuum
from electrical outlet.
2. Remove the filter door (located on the back
of the vacuum) by pulling down on the filter
door and pulling it toward you.
3. Remove the post-motor HEPA media filter by
grasping the lip of the filter frame and
pulling out toward you.
4. Replace the post-motor HEPA media filter
with a new filter.
NOTE: The post-motor filter is a white,
pleated HEPA media filter. This filter is NOT
washable and must be replaced when it
becomes dirty.
5. Replace the filter door by inserting the two
tabs at the bottom of the filter door, pushing
down on the bottom of the filter door and
pushing it back into the vacuum. Be sure the
top tabs are secured.
IMPORTANT: Make sure the dirt cup is
empty before you replace or clean these
filters.
1. To remove the dirt cup HEPA media filter, pull
down on the front snap.
2. Remove and replace as necessary.
NOTE: The dirt cup HEPA media filter is a
white, pleated HEPA media filter. This filter
is NOT washable and must be replaced
when it becomes dirty.
Replacing the post-motor HEPA media filter
Post-Motor
HEPA Media Filter
2.
3.
1.
Replacing the dirt cup HEPA media filter & cleaning the foam filter