Filter
Top Products
16
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
8
w ww.b is se ll .c om
Pet Hair Eraser Floor Nozzle continued
1. To vacuum rugs and carpeted surfaces, flip
down the Pet Hair Lifter until it clicks into
place on the front of the Pet Hair Eraser
Floor Nozzle. Then push the brush switch to
the carpet position to pull the
brushes up into the Pet Hair Eraser Floor Nozzle.
2. To vacuum bare floors, push the brush
switch to the bare floor position to
extend the brushes down from the Pet Hair
Eraser Floor Nozzle. Then flip up the Pet Hair
Lifter by pushing the yellow release button.
This will flip the Pet Hair Lifter up and out of
the way.
Variable suction power control
The variable suction power control is located
on the back of the vacuum. Turn the control
toward the larger dots for maximum suction.
Turn the control toward the smaller dots to
minimize suction for lightly soiled areas or
delicate fabrics.
Air flow regulator
Open the air flow regulator by sliding the
regulator back towards the handle to an open
position to reduce suction for delicate fabrics.
Close the air flow regulator by sliding the regulator
down to the closed position for full suction.
Clean filter indicator
The clean filter indicator is located between the
power button and the automatic cord rewind
button. It will monitor your air flow and let you
know when it is time to clean or replace your
filters. If the indicator turns orange while you
are vacuuming, your filters need to be cleaned
or replaced. If the indicator remains orange,
even after cleaning or replacing your filters,
turn the vacuum off and check for a clog in the
hose or tool.
NOTE: The indicator may turn orange when
using the tools due to the restricted airflow.
This does not necessarily mean that the
filters need to be cleaned or replaced. If the
indicator does not turn off once the tool is
removed, check for a clog in the hose/tools
or clean or replace your filters.
Operations
1.
Brush Down
Brush Up
2.
Release Button
Clean Filter
Indicator