Filter
Top Products
11
www.bissell.com 800.237.7691
Replace drive belt
Use only BISSELL Style 10 Replacement Belts
(#32074) in your BISSELL PowerForce Bagless.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum
cleaner (Steps 1-4 of Check rotating floor brush
and drive belt), grasp old drive belt and remove
from motor pulley. Discard old drive belt.
3. Place new drive belt over motor pulley and
stretch other end over rotating floor brush in
the space between the bristles.
4. Place ends of rotating floor brush down into
slots on sides as shown.
5. Turn rotating floor brush by hand several times
in direction of motor pulley. If properly installed,
drive belt will center itself on rotating brush.
6. Reposition brush cover and four screws. Make
sure end of brush cover is snapped into place.
Clearing clog
Low suction, poor pickup, or no suction may be
due to a clog in the vacuum cleaner. If you notice
a change in the sound of the vacuum motor or a
reduction in the spinning action in the dirt
container, check for clogs.
1. Unplug cleaner from electrical outlet.
2. Empty dirt container.
3.
Check upper tank and louvers for build up or
clogs. Check to make sure louvers are installed
correctly. To unlock the louvers, grasp the rim
and turn toward the left. Pull straight down to
remove. If the louvers are missing or not locked
into place, check and clear the tube in the
center of the dirt container.
4. Remove the Twist ‘n Snap hose from the vacuum
by turning to the left. Check the suction inlet, hose
and hose wand for clogs. Remove any clogs from
the hose using a long, narrow object.
5. Check the foot hose for clogs. If needed,
remove the screw attaching the hose wand
base to the vacuum. Straighten the foot hose
and unclog with a long, narrow object.
6. If the clog persists, follow the instructions for
checking the rotating floor brush on page 10
and inspect the air passageway for obstructions.
Maintenance and care
Brush
Cover
Press here
Suction
Inlet
Air Passageway
Louvers
Hose
Wand Base