Filter
Top Products
8
w ww.b is se ll .c a 1 -8 00 -2 63 -2 53 5
Maintenance and care
To maintain maximum cleaning performance
from your BISSELL PowerForce Bagless, perform
these simple maintenance steps.
1. Empty the dirt container when the dirt
reaches the “Full” line on the side.
2. Check the inner and outer circular filters,
and the pre-motor filter at least once a
month and clean or replace as needed.
3. Clean or replace the post-motor filter every
three to six months.
Note: More frequent filter cleaning or
replacing may be necessary if you are
vacuuming new carpet, fine dust, or have
allergy concerns. Follow the instructions on
the following pages to perform these simple
maintenance steps.
Emptying dirt container
The dirt container needs to be emptied when
the dirt reaches the “Full” line on the side of the
container.
1. Unplug cleaner from electrical outlet.
2. Slide the Lock ‘n Seal lever to the "Unlock"
position.
3. Grasp handle and pull the dirt container
straight out to remove from vacuum.
4. Empty dirt into garbage container.
5. Put the dirt container back in the vacuum
and slide the lever to the "Lock" position.
Note: The dirt container may be washed in
warm water with a mild detergent. Remove
the filter cup from the bottom before
washing. Reassemble and make sure it is
completely dry before using again.
WAR NING:
To reduce the risk of
electric shock, turn
power switch OFF and
disconnect polarized
plug from electrical outlet
before performing
maintenance or
troubleshooting checks.
Tip:
For maximum cleaning
performance, check
and clean, or replace
all filters as suggested.
Lock Position
Full Line
Unlock
Position