Bissell 64D9 Carpet Cleaner User Manual


 
12
www.bissell.com 800.237.7691
Operation
1. Turn power switch off. Remove the 2-in-1 water
tank from the base using the tank carry handle.
Carry the tank like a bucket to a utility sink or
outside where you will dispose of the collection
water. Remove the top of the tank by rotating the
handle forward to unlatch lid and lifting lid off tank.
2. Empty collection water from bottom of tank.
3. After each use, remove and rinse the lint
screen located on the tank lid.
4. If nozzle needs to be cleaned: remove by grasping
handle at the top and pulling forward. Clean
removable nozzle by rinsing under running water.
5. When finished, replace nozzle by slightly
raising front of machine to line up slots on the
base with the hooks on nozzle. Attach at base
first and then click nozzle into place.
NOTE: If nozzle is not attached properly loss
of suction will occur.
6. To continue carpet cleaning, refer back to
pages 10 through 11, beginning with “Fill
the 2-in-1 water tank” on page 10.
If cleaning is complete, refer to the “Maintenance
and care” section on page 15.
Ready Tools™
Your ProHeat deep cleaner comes equipped with
a hose and at least one attachment for cleaning
stairs, upholstery, and more.
Important! If using the machine to clean
upholstery, check upholstery tags.
1. Check manufacturer’s tag before cleaning. “W”
or “WS” on the tag means you can use your
PROHeat. If the tag is coded with “X” or “S”
(with a diagonal strike through), or says “Dry
Clean Only,” do not proceed. Do not use on vel-
vet or silk. If manufacturer’s tag is missing or not
coded, check with your furniture dealer.
2. Check for colorfastness in an inconspicuous place.
3. If possible, check upholstery stuffing. Colored
stuffing may bleed through fabric when wet.
4. Plan activities to give upholstery time to dry.
2.
3.
1.
5.
Lint Screen
Empty the 2-in-1 water tank/ clean removable nozzle
4.
Manufacturer’s tag
ug120-4043_25A3_608.indd 12 6/26/08 2:23:12 PM