Filter
Top Products
w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Assembly
Assembling your new Vac&Shine is a 3
Step Process, requiring no tools.
1. Insert foot into body of unit until you hear
a click.
2. Place the Solution Tube onto the spray
connector.
3. Insert the handle into the body of the unit.
Turn handle until key in handle falls into
position until you hear a "click".
Charging
Note: The unit will come partially
charged. Charge completely before
using 12 hours or overnight.
Average run time for Dry Vacuuming is
12 minutes.
A. To charge, place the charger plug into
the Charging Port on the side of the unit.
Make sure it is in securely and the charge
indicator light is illuminated. Make sure
power switch is in the "off" position.
Filling the Clean Tank
1. Remove tank from the unit.
2. Unscrew the black cap on the bottom of
the solution tank and remove the insert.
3. Fill with Tap Water to the full line and
fill the remainder with BISSELL 2x Hard
Floor or Wood Floor Solutions formulas.
Replace the cap and insert assembly.
Place the full tank back into the unit.
1.
1.
3.
A.
2.
2.
5
Tip:
You will only utilize battery charge
while dry vacuuming. For wet
mopping, the batteries are not
used, extending usage time.
Tip:
Gently push the tank into place.
If you see air bubbles in the
tank, it is seated properly.