Filter
Top Products
7
www.bissell.com 800.237.7691
Switching from Dry Vac to Wet Mop
1. To change from dry vacuuming to wet
cleaning simply flip the unit around!
Wet Mop
1. By squeezing the trigger, you will turn
off the vacuum suction.
2. Water and Solution will flow to the 2 spray
tips on the Wet Mop side. Gently mop the
floor with the Gentle Clean™ MicroFiber pad.
Depressing the trigger will dispense water and
solution based on your cleaning job.
Sticky, dirty areas may require more water
and solution.
Floor will need to air dry for 3-5 minutes.
Cleaning the Gentle Clean™
MicroFiber Pad
1. After Wet Mopping, remove the MicroFiber
Pad to launder or wash.
To wash, simply toss in the wash, air dry and reuse.
No need to buy disposable cloths every time you use
your Flip-Ease!
Storing and Charging your Flip-Ease
Your Flip-Ease can be stored Ready-to-Use, by
leaving water and formula in the Clean Tank.
Be sure to remove the MicroFiber Pad to clean.
1. To charge while storing, place the charger
plug into the charging port on the side of the
unit. Make sure it is securely connected and
the charger indicator light is illuminated.
How to use your Flip-Ease Continued
Maintenance and Care
1
1
Charger
Plug
Tip:
You do not have
to empty the Dirty
Tank before wet
mopping.
1
Tip:
When the trigger
is squeezed the
vacuum suction
will stop; extending
battery life.
2
Spray Tips
ug603-6913_5288_606.indd 7ug603-6913_5288_606.indd 7 6/20/06 9:12:27 AM6/20/06 9:12:27 AM