Filter
Top Products
9
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
While Wet Cleaning, you will see dirty water collected in
the Dirty Tank. When the Tank is full, the white Float in
the Dirty Tank will rise to the top, making a noticeable
sound to let you know it is time to empty the Dirty Tank.
Remove the Dirty Tank Lid. Dump the dirty water and
debris into the sink, toilet, laundry tub or outside. Rinse the
Tank out with warm water and replace it in the unit.
While the Dirty Tank is out of the unit, remove the
Pleated Filter from the top of the Tank. Remove dirt and
debris from the pleats by gently tapping the Filter over
the wastebasket or outside.
The Pleated Filter can also be rinsed under
water to clean.
NOTE: If the Pleated Filter is rinsed with warm
water to clean, it is recommended to leave it out of
the unit to air dry before placing it back in the unit.
Gentle Clean™ Brush
Remove the Gentle Clean Brush from the unit and rinse
under warm water.
Gentle Clean™ Pad
Remove the Gentle Clean Pad Card from the unit. Peel the
Pad from the Pad Card and toss in the wash!
Remove the Wet Cleaning Nozzle by pulling tab on right
side of Nozzle. Rinse any dirt and grime off the Nozzle
under warm tap water.
To replace the Wet Cleaning Nozzle, insert the 4 tabs
along the bottom of the Nozzle Window first and gently
snap the Wet Cleaning Nozzle back into place.
Checking The Filter
Tip:
If there are large pieces of
debris in the water, you may
not want to empty the Tank
into your sink.
When You're Finished
Emptying the Dirty Tank
Cleaning The Gentle Clean™ Brush or Pad
Removing Wet Cleaning Nozzle
Tip:
While using the Flip-It in the
Wet Cleaning mode, make
sure to listen for the change
in the sound to alert you
when the Dirty Tank is full.
Dirty Tank Is Full
ug603_6719_5200E_305.indd 9ug603_6719_5200E_305.indd 9 11/16/05 2:58:47 PM11/16/05 2:58:47 PM