Bissell 46B4 Carpet Cleaner User Manual


 
w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Operations
w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Before you clean
The Steam & Sweep can be used
as a sweeper and a steam mop
at the same time. For best results,
use the Steam & Sweep's powerful
sweeper to clear floor of dust and
small debris before mopping.
1. Turn the brush switch to the On ( I )
position to activate the brush.
2. To empty the dirt container, turn the
power off, gently tap the release
pedal on the swivel head. Lift unit
straight up leaving bin on floor and
empty into a trash can. The dirt con-
tainer may be warm to the touch.
3. Replace the dirt container by
pushing it back into the swivel head
until it snaps back into place.
Steam cleaning hard floors
Your Steam & Sweep is designed
to clean hard flooring such as
ceramic tile, vinyl, marble, stone
and sealed hard wood floors. Use
of your Steam & Sweep on waxed
or some unwaxed floors may
result in a diminished glossiness.
The Steam & Sweep is not for
use on unsealed wood floors.
For best results, test in an
inconspicuous area and check the
care instructions from your flooring
manufacturer.
1. When the ready light illuminates,
begin cleaning by slowly passing
over the surface while pressing the
steam on demand trigger to emit
steam as needed.
2. To sanitize an area of your floor,
(attack invisible germs and bacteria)
leave the Steam & Sweep over the
area for a minimum of 15 seconds,
but no longer than 20 seconds. For
larger areas, overlap swivel head
placement.
3. When the Steam & Sweep stops
emitting steam, turn the unit off.
Simply remove the water tank, refill,
and continue cleaning.
1.
2.
Power Switch
Brush Switch
Dirt Bin
Release Pedal
8
WARNING:
Never put descaling
aromatic, alcoholic, or
detergent products into
the steam cleaner, as this
may damage it or make it
unsafe for use.
Tip:
During first use, it may take
several seconds for the Steam &
Sweep to begin steaming. The
water needs to flow through the
filter to the heater. This delay will
only occur during initial use or
when using a new filter.
Tip:
The Steam & Sweep may be
used as both a steam mop and a
sweeper at the same time.