Filter
Top Products
14
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Maintenance and care
Replace lightbulb
1. Unplug the vacuum from electrical outlet.
2. Using a flat bladed screwdriver, pry the tab
on the left and right side out and pull out to
remove the lens.
3. Remove the bulb from the socket by
grasping the bulb and pulling gently. Install
the new bulb by pushing it gently into the
socket until the bulb snaps into place.
4. Reposition the lens and snap it back
into place.
Maintaining Pet TurboBrush
®
The Pet TurboBrush should be checked regularly
for clogs or debris wrapping around the brush.
1. Unplug the vacuum from electrical outlet.
2. If a clog is present or debris is visible, unscrew
the two screws on the back of the TurboBrush to
remove the faceplate and clear any obstructions.
3. To clean debris from the brush, remove the
brush from the drive belt and clean debris.
4. Reposition the drive belt on the brush.
Place ends of brush in slots on sides.
Reposition faceplate and secure with
two screws.
NOTE: This tool is designed to remove pet
hair from upholstered or carpeted surfaces.
It should not be used on pets.
2.
3.
4.