Bissell 35K3 Carpet Cleaner User Manual


 
Operations
12
Cleaning with Deep Reach™ Tool
1. Set tool on soiled surfaces and press the trig-
ger to spray solution onto the soiled area to
be cleaned.
2. Slowly move the tool back and forth over
the soiled surface, keeping the tool in con-
tact with the carpet.
Release trigger and move tool slowly
over the soiled area to suction up water
and dirt.
4. Continue to clean the area, working in
small sections, until no more dirt can be
removed.
Empty dirty tank
Follow the instructions under Empty
dirty tank section on page 9 of the
Upright cleaning mode section.
Replacing portable machine on base
1. Align the product as the graphic shows,
with the cord side on the left and hose
side on the right.
2. Push down the portable spot cleaner
until you hear it click securely into
place. Test the fit by pulling up on the
carry handle to make sure it is secure.
Cleaning portable machine
1. Remove and rinse the tools in clean, run-
ning water. Dry and replace in the tool
storage provided.
2. It is recommended that you suction clean
water from a bowl to rinse out the hose.
Then lift end of hose and stretch out to
ensure all water is cleared from hose.
3. Coil flex hose around the hose wrap
and secure with latch.
4. Check suction gate and if it appears
dirty, follow steps 1-4 under Cleaning
Suction Gate on page 13.
1.
3.
Portable spot cleaning mode continued
Graphic
1.