Filter
Top Products
How To Use This Guide
This User’s Guide has been designed to help you
get the most satisfaction from your BISSELL CleanView
II.You’ll find assembly and operating instructions,
safety precautions, as well as maintenance and
troubleshooting instructions. Please read this Guide
thoroughly before assembling your vacuum cleaner.
Pay particular attention to the product diagram,
assembly instructions, and part names. Locate and
organize all parts before assembly. Familiarize
yourself with the parts and where they fit. Following
this User’s Guide will greatly enhance your ability to
get the most performance from your BISSELL
CleanView II for many years.
The only tool you’ll need to assemble your vacuum
cleaner is a screwdriver.
Locate the vacuum Handle and remove the screw
packet taped to the base of the Handle.
Stand the vacuum upright and slide the base of
the Handle firmly into the grooves at the top of the
vacuum body.
Check to be sure the Handle is fitted to the vacuum
body. If there is a gap in front, continue to push firmly
until the Handle is flush.
Insert the screw provided from the screw packet into the
existing hole.Tighten securely with a screwdriver.
Attach the Twist ‘n Snap
™
Hose by lining up the tabs on
the base with the corresponding notches on the back of
the vacuum as shown.
Turn the Twist ‘n Snap Hose to the right to lock the hose
into place.
Grasping the Quick Reach Handle, slide the end of the
Hose Wand onto the Hose Wand Base. Snap the Hose
into the Hose Clip.
NOTE: The Powerfoot will not operate
effectively unless the Hose Wand is
firmly attached.
1.
Attach Handle To Vacuum
5
How To Put It Together
2.
3.
4.
Attach Vacuum Hose and Tools
1.
2.
WARNING:
Plastic film can be
dangerous. To avoid
danger of suffocation,
keep away from
babies and children.
3.