Filter
Top Products
5
1.
3.
2.
1.
3.
4.
5.
1a. - 3a
This User’s Guide has been designed to help you get the utmost satisfaction
from your BISSELL PowerForce. You’ll find assembly and operating instructions,
safety precautions, as well as maintenance and troubleshooting instructions.
Please read this Guide thoroughly before assembling your vacuum cleaner.
Pay particular attention to the product diagram, assembly instructions, and
part names. Locate and organize all parts before assembly. Following this
User’s Guide will greatly enhance your ability to get the most performance
from your BISSELL PowerForce for many years.
The only tool you’ll need to assemble your vacuum cleaner is a screwdriver.
Stand the vacuum upright and slide the base of the Handle firmly into the
grooves at the top of the vacuum body.
Check to be sure the Handle is fitted to the vacuum body. If there is a gap in
front, continue to push firmly until the Handle is flush.
Insert one screw from the assembly packet into the existing hole in the back of
the Handle. Tighten securely with a screwdriver.
Position the Hose Assembly on the back of the vacuum as shown.
Attach the Hose with two screws from the assembly packet. Tighten
securely with a screwdriver.
For Models with the Twist ‘n Snap
™
Hose
Position the Twist ‘n Snap Hose assembly on the back of the vacuum.
Line up the tabs on the base of the Twist ‘n Snap Hose with the
corresponding tab notches on the hose collar as shown.
Turn the Twist ‘n Snap Hose to the right to lock the hose into place.
Grasping the Quick Reach
®
Handle, slide the end of the Hose Wand onto
the Suction Intake Opening. Snap the Hose into the Hose Clip.
NOTE: The Powerfoot will not operate effectively unless the Hose
Wand is firmly attached to the Suction Intake Opening.
Place the Crevice Tool inside the Extension Wand and slide them into the
Storage Clip as shown.
Snap the Combination Upholstery/Dusting Brush Tool into the Storage Clip
as shown.
Press the Handle Release Pedal with your foot to place your BISSELL PowerForce
into one of three cleaning positions.
Upright- For storage and above floor cleaning with special tools.
Normal Cleaning- Press Handle Release Pedal once. Use for most
household floor cleaning tasks.
Low Cleaning- With the vacuum in normal cleaning position press Handle
Release Pedal again. Use for reaching under low furniture
such as tables, chairs and beds.
How To Use This Guide
WARNING:
Plastic film can be dangerous.
To avoid danger of suffocation,
keep away from babies
and children.
1.
2.
3.
1.
2.
3.
4.
5.
1a
2a
3a
Handle Position
How To Use Your BISSELL PowerForce
1.
2.
3.
How To Assemble
Attach Handle to Vacuum
Attach Vacuum Hose and Tools
Tip:
Before cleaning under
low furniture, check
area first for objects
that might harm the
unit or block the
Vacuum Hose.