Filter
Top Products
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
9
Operations
To begin cleaning
1. Place the filled clean water/solution
tank onto the unit.
2. Plug your SpotBot in. The power light will
illuminate, indicating your SpotBot is ready
to go.
Automated cleaning
1. Place the unit directly over the spot or
stain, making sure the stain is in the
center of the cleaning area.
2. Select which cleaning cycle (surface
stain or set-in) you would like to use.
SpotBot will begin spraying, brushing
and suctioning the soiled area, in a
pre-programmed cycle. Both cycles
have been tested and proven to deliver
superior cleaning results, taking the
guesswork and effort out of cleaning for
you.
3. When the cleaning cycle you have
selected is complete, the SpotBot will
beep. The beep will continue until you
hit the STOP button.
4. Pick up the unit and check the area that
was cleaned.
5. If you use Oxy GEN2, it will continue
to work for the next six to eight hours,
cleaning your spots and stains all the
way to the backing of the carpet.
Tip:
Dry vacuum the area first
before spot cleaning with the
SpotBot.