Filter
Top Products
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Operations
8
How to begin
Using the Automatic Smart System™
Your new SpotBot features an
Automatic Smart System that takes
the guesswork out of spot and stain
removal. With the touch of a button,
you can select the cleaning cycle to use
your preferred method of cleaning.
1. Surface Stain Cycle This cycle has
been designed for stains that are on the
surface of your carpeting. This cycle will
run for approximately 3 minutes.
2. Set-In Stain Cycle Use on stains that
have had a period of time to set-in.
These are typically the most difficult
stain types to remove. This cycle runs for
approximately 6 minutes.
3. Manual/Hose By selecting this option
you can clean spots and stains manually
on surfaces such as upholstery, stairs, car
interiors, or any other hard to reach area.
4. Pause/Resume If you press the
pause/resume button once, it will pause
the cleaning cycle. Press again to
resume your current cleaning cycle.
5. Stop By pressing the red stop but-
ton, you will stop the cleaning cycle
completely. To begin cleaning again,
you will need to start over and select a
cleaning cycle.
6. Status Indicator Lights Will give
you a visual update on the cleaning
cycle. During a cleaning cycle you
will hear changes in the sound of the
machine that correspond with a given
step. When your cleaning cycle is
complete, the Finish light will illuminate
and you will hear a “beep” every five
seconds until you depress the stop
button.
Tip:
Some spots and spills
require that you pick up the
chunky debris with a rag
or towel before you begin
cleaning in the automatic
or manual cycles.