Filter
Top Products
Your Go Vac is a quick and easy way to clean
up around the house, inside the car or truck,
or in the workroom.
1. Release the Go Vac from the
Charging Base by lifting it
straight up and out.
2. Tip back the Handle into
typical use position, and
your Go Vac turns on by
itself. To turn Go Vac off again,
return Handle to upright position.
3. To clean stairs, vehicles or small areas,
detach the Handle by depressing the
button where the bottom of the Handle
slides into the Go Vac, and pull the entire
Handle assembly out. Use the Go Vac by
holding the built-in hand grip.
4. When done, replace the Handle (if
detached) and place the Go Vac in the
Charging Base. Make certain red charging
light is on when Go Vac is in place.
NOTE: For Model 3301, simply remove the Charging
Plug from the port at the motor side of the
Go Vac, and use as above.
6
How to use your Go Vac
Your Go Vac may be stored in the Charging Base whenever it is
not in use. When Go Vac is charging, it may become warm to
the touch. This is normal, and no cause for concern. Here are
some things to remember about charging:
1. When completely charged, your Go Vac provides over 12
minutes of full cleaning power.
2. When charging for the first time, allow to charge
uninterrupted for at least 24 hours. Thereafter, a 12 -16
hour charge will renew the Go Vac battery.
3. Model 3300 features a single red Indicator Light. This
light does not go off when the Go Vac is fully charged.
Unplugging the Charging Base cord from the wall outlet
after 6 - 8 hours will extend the life of the battery.
4. Model 3302 [Fast Charger] features a red and a green
Indicator Light. When in charge mode, the red light will
glow. When the battery is fully charged and ready for use,
the red light will go out and the green light will glow -
usually in 3 hours.
IMPORTANT NOTE: If you purchased a 3302 Go Vac unit equipped
with the fast charger, you should let the vacuum cool down before
placing into the charging base. The charger features a heat sensitive
device that will indicate to the vacuum that it is already charged.
(Placing the unit while warm, into the vase will take longer to charge.)
5. Decreased operating time may indicate that the battery has
built up a charging resistance. To recharge, first completely
exhaust the battery, recharge it, then exhaust it again before
recharging a second time. This procedure may be required
more than once. If your battery still fails to recharge, or
does not hold a charge of normal duration, call:
BISSELL Consumer Services
1-800-237-7691
Monday - Friday 8 a.m. — 7 p.m. EST
Saturday 9 a.m. — 2 p.m. EST
Or visit our website @ www.bissell.com
NOTE: Charging Bases are not interchangeable
between models.
Charging the battery
On
Off