w w w . b i s s e l l . c o m
Assembly
Changing the battery
1. When completely charged, the Perfect
Sweep TURBO provides up to 60
minutes of full cleaning power.
2. When charging for the first time, allow
to charge uninterrupted for at least 16
hours. Thereafter, charge at least 12
hours to renew the Perfect Sweep TURBO
battery. The charging indicator light will
illuminate when properly connected and
will not turn off when fully charged.
Note: The power switch must be in
the OFF position when charging.
3. Decreased operating time may indicate
the battery has built up a charging
resistance. To recharge, first completely
exhaust the battery, recharge it, then
exhaust it again before recharging a
second time. This procedure may be
required more than once.
4. When charging is complete, be sure to
unplug the Perfect Sweep TURBO from
the charger.
Using your Perfect Sweep TURBO
The Perfect Sweep TURBO is a quick
and easy way to clean your bare
floors and carpet.
1. Tip back the handle into typical use posi-
tion and gently tap the power switch on the
sweeper with your foot.
Note: The unit will not turn on if the
dirt cup is not secure.
2. To clean small areas, detach the handle
by depressing the handle clip button
where the bottom of the handle slides
into the Perfect Sweep TURBO and pull
the entire handle assembly out. Use the
Perfect Sweep TURBO by holding the
built-in hand grip.
3. When done, replace the handle (if
detached) and store for the next use.
5
Operations
ATTENTION:
If your battery still fails to
recharge or does not hold a
charge of normal duration, call:
BISSELL Consumer Services
Listed on page 8
Or visit our website at
www.bissell.com
1
2
WARNING:
Perfect Sweep TURBO
will not pick up crayons,
marbles, and other large
or hard objects.