Filter
Top Products
12
www.bissell.com 800.237.7691
Maintenance and care
Cleaning a clog
Low suction or poor pickup may be due to a clog
in the vacuum cleaner. If you notice a change
in the sound of the motor or a reduction in the
spinning action, check for clogs.
1. Unplug cleaner from electrical outlet.
2. Empty dirt container.
3. Check upper tank for build up or clogs.
4. Check the suction inlet for a clog.
5. Grasp the quick reach handle and lift hose
wand to separate from the suction opening.
Check for a clog in the base, the wand or
the hose.
6. Remove the screw attaching the hose wand
base to the vacuum. Straighten the hose
wand base and unclog with long, narrow
object such as a broom stick.
7. If the clog persists, follow the instructions
for Checking the rotating floor brush on
page 11 and inspect the air passageway for
obstructions.
Replace light bulb
Use only BISSELL Replacement Bulbs in your
BISSELL CleanView Helix.
1. Unplug cleaner from electrical outlet
2. Using a flat screwdriver, table knife or coin,
insert into the slot on the right of the lens
and gently push inner latch to the left as
shown to remove the lens.
3. Reposition lens by inserting the tab on left
side and then pushing the right side back
into place.
3.
4.
6.
2.
3.