Filter
Top Products
8
www.bissell.com 800.237.7691
Charging the battery
When completely charged, the cordless bare
floor vacuum provides up to 20 minutes of full
cleaning power.
Note: When charging for first time, allow
time to charge uninterrupted for at least 16
hours. Thereafter, charge at least 12 hours
to renew the
cordless bare floor vacuum.
1. Plug charging cord into charging port.
2. Decreased operating time may indicate
battery has built up a charging resistance.
To recharge, first completely exhaust
battery, recharge it, then exhaust it again
before recharging a second time. This
procedure may be required more than once.
3. When charging is complete, be sure to unplug
cordless bare floor vacuum from charger. This
will maximize the battery’s lifetime.
Note: Red light will remain on as long as
unit is receiving power. Red light will NOT
shut off once battery is fully charged.
Maintenance and care
ATTENTION:
The power switch must
be in the OFF position
when charging.
WARNING: This product contains a
nickel-cadmium (Ni-Cd) rechargeable battery pack.
According to Federal and State regulations, removal
and proper disposal of Ni-Cd batteries is required.
For removal of the battery pack in your cordless bare
floor vacuum, see instructions below:
Do not unscrew battery door for any purpose other than to recycle
the battery assembly at end of unit's life.
1. IMPORTANT: Unplug charger.
2. Remove filter and dirt cup assembly.
3. Remove shrink wrap battery pack by unscrewing battery door.
4. Remove wire connectors from the battery pack.
5. Keep battery pack together - DO NOT separate individual batteries.
6. Discard remainder of product.
For specific disposal instructions of batteries, please contact:
RBRC (Rechargeable Battery Recycling Corporation) 1-800-822-8837 or
visit the website: www.rbrc.com
Caution: Altering battery in any way will destroy the appliance and
invalidate the warranty.
ug110-4044_21R9_408.indd 8ug110-4044_21R9_408.indd 8 5/30/08 10:30:19 AM5/30/08 10:30:19 AM