Filter
Top Products
8
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Cleaning hard floors continued
1. When the ready light illuminates, begin cleaning
by slowly passing over surface while pressing the
steam on demand trigger to emit steam as needed.
2. To sanitize an area of your floor, (attack invisible
germs and bacteria) leave the Steam Mop Max
over area for a minimum 15 seconds, but no
longer than 20 seconds. For larger areas, over-
lap swivel head placement.
3. When the Steam Mop Max stops emitting steam,
simply remove the water tank, refill, and
continue cleaning.
Carpet Refresher Attachment
This accessory is recommended for the
refreshing of carpets. Once the steam mop is
cradled in the carpet refresher attachment, it will
easily glide over the carpet.
NOTE: Always be sure a mop pad is in place
before placing in carpet refresher attachment.
Only white mop pads should be used with the
carpet attachment. Do not use carpet attach-
ment on spots or stains, or glide it over the
same spot for longer than 20 seconds.
1. Attach the mop pad to the swivel mop head. As
directed in step 1 on page 4.
2. Place the swivel mop head, with mop pad
attached, in the carpet refresher attachment.
Note: that the Steam Mop rests in the car-
pet refresher attachment and may not stay
attached to the swivel mop head. It is meant to
glide over the carpet.
3. Fill the water tank with water. Begin refreshing
your carpet or rug by pushing the Steam Mop
in a forward and backward motion, releasing
steam as you go.
4. When you have finished refreshing your carpet
or rug, unplug the steam mop and remove from
the carpet or rug.
NOTE: Move the Steam Mop and carpet
refresher attachment in a continuous motion
until you are finished. This product is not
intended to be used as a carpet cleaner, only a
carpet refresher or deodorizer. Never attempt
to use the Steam Mop on carpet without the
carpet refresher attachment in place. DO NOT
leave the mop in a stationary position.
Operation
WARNING:
Never put descaling,
aromatic, alcoholic, or
detergent products into
the steam cleaner, as
this may damage it or
make it unsafe for use.
Tip:
During first use, it may
take several seconds
for the Steam Mop Max
to begin steaming. The
water needs to flow
through the filter to the
heater. This delay will only
occur during initial use or
when using a new filter.
2
3
CAUTION:
Never put descaling,
alcoholic, or deter-
gent products into
the steam cleaner,
as this may damage
it or make it unsafe
for use.
ug120-4108_21H6_709.indd 8 7/10/09 10:34 AM