Filter
Top Products
Empty and rinse Clean Water Tank.
Using the Formula Measuring Cap, add two (2) capfuls of
BISSELL
®
Floor Cleansing Formula
™
to the Clean Water
Tank. Add 1/2-gallon of hot (NOT boiling) tap water. Fill
only to fill line – do not overfill.
Replace and turn the Formula Measuring Cap clockwise
until secure.
Rotate Quick Release Cord Wrap and plug in.
Turn Power Switch located on the back of Lower Body to
( ) ON.
Slowly move QuickSteamer back and forth over soiled
surface one time while depressing Trigger. Do not overwet.
Repeat motion over same area without depressing Trigger.
Repeat Steps 1 and 2 until no more dirt can be removed.
If Floor Nozzle stops spraying, turn Power Switch to
OFF ( ) and check water and cleaning solution levels.
Refill if needed.
Cleaning Bare Floors
1.
2.
3.
4.
Attaching the Bare Floor Tool Continued
5.
6.
7.
8.
9.
CAUTION:
Do not lay QuickSteame
on its back with Clean
Water Tank in place. Do
not tip up foot with Dirty
Water Tank in place.
Bare Floor Tool
8