Filter
Top Products
w w w . b i s s e l l . c o m
0perations
6
Fill the tank
1. Remove the clean water/solution tank by
lifting it straight up, then away from the
lower body.
2. Unscrew the black cap at the bottom of
the clean water/solution tank.
3. Fill to the FORMULA line with BISSELL 2X
cleaning formula. Fill the rest of the tank
with hand hot (not boiling) tap water to
the water fill line. Replace and tighten the
black cap.
4. Place clean water/solution tank on lower
body.
5. Rotate Quick Release Cord Wrap™ to
release the power cord and plug into an
outlet.
Carpet cleaning
1. With your foot, press the red power
switch [located in foot of unit] ON .
2. With foot, press the detent lever on left
side of lower body.
3. Depress spray trigger to spray cleaning
solution. Do not overwet.
4. To suction up water, repeat motion over same
area without pressing the spray trigger.
5. Repeat steps 3 and 4 until no more dirt
can be removed.
6. Continue to clean entire carpet, working
in 1m x 1m sections.
7. Empty the collection tank when dirty water
reaches the full line, or when the clean
water/solution tank is empty.
8. If floor nozzle stops spraying, turn power
switch OFF and check water and cleaning
solution levels. Refill if needed.
Tip:
It is recommended
that every time your
clean water/solution
tank needs refilling, that
you empty the contents
of the collection tank. If
the collection tank gets
too full, you may begin
to see foam spitting out
of the vent cover. If this
happens empty the
collection tank.
WARNING:
To reduce the risk of fire, use only
BISSELL advanced cleaning formulas
for full size machines in your deep
cleaner. Use of cleaning formulas
that contain lemon or pine oil may
damage this appliance and void
warranty. Chemical spot cleaners or
solvent-based soil removers should
not be used. These products may
react with the plastic materials used in
your deep cleaner, causing cracking
or pitting.
2.
Tip:
Deep cleaning spots, spills and high
traffic areas on a regular basis can
prolong carpet life.