Filter
Top Products
WARNING:
To reduce the risk of electric
shock, turn Power Switch OFF
and disconnect polarized plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
Maintenance and care
Replace light bulb
1. Unplug cleaner from electrical outlet.
2. Remove detachable canister and recline
handle of vacuum.
3. Using a screwdriver, remove the one screw
as shown and lift off the lens.
4. Remove the bulb from the socket by grasping
bulb and pulling straight out. Install the new
bulb by pushing it gently into the socket until
the bulb snaps into place.
5. Reposition lens and secure with the one
screw.
TurboBrush maintenance
The TurboBrush should be checked regularly
for clogs or debris wrapping around the
brush roll.
1. Unplug vacuum from electrical outlet.
2. If a clog is present or debris is visible,
unscrew the two screws on the back of the
TurboBrush to remove the faceplate and clear
any obstructions.
3. To clean debris from the brush roll, remove
the screw located on the belt cover. Lift the
belt cover. Remove the brush roll from the
drive belt and clean debris.
4. Reposition the drive belt on the brush roll.
Place ends of brush roll in slots on sides
as shown. Reposition belt cover and secure
with shorter screw. Reposition faceplate and
secure with two longer screws.
13
w ww.b is se ll .c a 1 -8 00 -2 63 -2 53 5
3. 4.
2.