Filter
Top Products
5
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
1. Slide upper body into lower body.
2. Secure with screws.
3. Slide handle assembly down into upper body
until it will go no further. Align screw slots.
4. Secure with screw.
5. Place solution tank on back of unit.
Before you clean
1. Remove easily moved furniture (chairs, lamps,
coffee/cocktail tables, etc.) from room if needed.
2. Vacuum carpet thoroughly.
3. Decide where to begin. Plan to leave a path open
to empty soiled water and refill cleaner.
Note: Carpeting will dry in three to four
hours, depending on carpet style and
air circulation in room. A floor fan
speeds drying
Fill the tank
1. Remove the solution tank by lifting it straight up,
then away from the lower body.
2. Unscrew the black cap at the bottom of the
solution tank.
3. Fill to the FORMULA line with BISSELL 2X Fiber
Cleansing formula. Fill the rest of the tank with
hot (not boiling) tap water to the water fill line.
Replace and tighten the black cap.
4. Place solution tank on lower body.
5. Rotate Quick Release Cord Wrap™ to release the
power cord and plug into an outlet.
Pre-Treating
Pre-treat stubborn stains and highly soiled
carpet in hallways and other high-traffic areas.
1. Generously spray BISSELL Tough Stain pre-cleaner
evenly over soiled area. DO NOT OVERWET CARPET
2. Wait 3-5 minutes before deep cleaning.
Assembly
1.
5.
3.
2.
4.
Operation
Tip:
Always vacuum
thoroughly before
you deep clean.
If possible, move
large furniture to an
area you will not be
cleaning.
WARNING:
To reduce the risk of fire, use only
BISSELL advanced cleaning formulas
for deep cleaning machines. Use
of cleaning formulas that contain
lemon or pine oil may damage
this appliance and void warranty.
Chemical spot cleaners or solvent-
based soil removers should not be
used. These products may react
with the plastic materials used in
your QuickSteamer, causing
cracking or pitting.
2.
Tip:
Deep cleaning spots,
spills and high traffic
areas on a regular
basis can prolong
carpet life.