Filter
Top Products
Cleaning spills from hard surfaces
1. Turn power switch “I” (ON).
2. Press front of Spot Lifter firmly against hard
surface to suction up spill.
3. Press trigger to spray cleaning solution.
4. Press front of Spot Lifter firmly against hard
surface to suction cleaning solution, as in step
2 above.
NOTE: If the Spot Lifter stops spraying,
turn unit “O” (OFF) and check the cleaning
solution level in the solution tank. Refill if
needed. Never run the unit without water or
cleaning solution.
Machine care
1. Turn the power switch to the “OFF”
position. ( O )
2. Carry the Spot Lifter to the sink or drain.
To empty the collection tank
1. Remove the collection tank by pressing the tank
release button at the top of the tank. The tank will
pivot out on a “hinge” at the bottom of the unit.
2. Remove the tank plug by turning approximately 1/4
turn counterclockwise and lifting out. Empty tank.
3. Thoroughly rinse the collection tank with clean
water. Be sure to rinse nozzle area.
4. Replace tank plug and turn approximately 1/4
turn clockwise, until snug.
5. To replace the tank, pivot bottom of tank back
into "hinge" and tilt up to handle. Press the tank
release button, and snap the tank into place. Test
for a secure fit before using.
NOTE: Check the solution tank. If a
significant amount of BISSELL Little
Green formula/water remains, you may
leave it in the solution tank for your next
cleaning task.
8
Operations (continued)
Maintenance and care
2.
Tip:
Check spray nozzle for accumulated
dirt or debris. If necessary, clean with
soft bristle brush.
3.
2.
3.
8
www.bissell.com 800.237.7691
ug603-5410_1719_806.indd 8ug603-5410_1719_806.indd 8 9/25/06 1:07:41 PM9/25/06 1:07:41 PM