Filter
Top Products
13
Machine Preparation
12. Set up machine following instructions in The Basics
section, pages 5-9. Be sure to thoroughly rinse out any
remaining Fiber Cleansing Formula
™
to prevent slippery
linoleum, vinyl, and tile floors. Use BISSELL Floor
Cleansing Formula
™
in the SmartMix
®
tank.
13. Check ReadyTools
™
switch - it should be set on
Floor Cleaning.
14. Choose the SmartMix
®
setting to match the cleaning job.
15. Plug into a proper outlet and turn Power Switch ON.
Turn SmartTemp
™
switch to ON. The SmartTemp
™
Ready Light illuminates when POWERSTEAMER
®
PROHEAT
™
PLUS is ready to clean.
Bare Floor Cleaning Technique
17. Slowly move the machine nozzle with Bare Floor Tool
forward and back over soiled surface one time while
pressing the trigger.
Caution: Do not over wet.
18. Repeat the motion without pressing the trigger using the
Bare Floor Tool to squeegee and suction up the dirty water.
19. Repeat steps 1 and 2 backing along the exit path.
20. Allow about 30 minutes for the floor to dry completely.
21. When the cleaning job is complete refer to the
Maintenance/Putting it Away section, page 14, for
machine cleanup and storage instructions.
22. To remove Bare Floor Tool gently bend long tab (right
side) outward and pull tool down away from nozzle.
Rinse thoroughly, dry and store.
Keep plenty of genuine BISSELL
Fiber Cleansing Formula
™
on
hand so you can clean whenever
it fits your schedule. Always use
genuine BISSELL deep cleaning
formulas. Non-BISSELL cleaning
solutions may harm the machine
and void the warranty.