Filter
Top Products
How To Assemble
The only thing you will need to assemble your cleaner is a
Phillips head screwdriver.
Slide Upper Handle onto Lower Handle.
Feed bundled Power Cord through Tool Caddy from caddy’s
flat side.
Align Upper Handle holes and Tool Caddy holes.
Place hex nut into back of the Tool Caddy and hold in place.
Insert bolt from front to back turning into the hex nut until snug.
Do not over tighten. Repeat for second bolt and hex nut.
Insert 2 screws into lower two holes. Turn until snug.
Snap tools into storage on the Tool Caddy.
Wrap Power Cord and Flex Hose as shown.
POWERSTEAMER is a home cleaning system that uses a com-
bination of hot tap water, BISSELL advanced deep cleaning
formula and suction to safely clean carpets and upholstery.
The Power Switch controls power to the machine.
Provides custom control for each cleaning job.
Lift the SmartMix
®
concentrate tank out of the machine base.
Turn the tank over so that the valve cap is in an upward position.
Unscrew the valve cap and fill the tank to the mark with
BISSELL Fiber Cleansing Formula.
Replace the valve cap turning until snug.
Replace SmartMix concentrate tank.
NOTE: If tank leaks, check for proper positioning
of o-ring.
5
1.
2.
Tip:
Deep cleaning
carpeting and
upholstery regularly
can reduce dust and
allergens in your
home.
SmartMix
®
1.
3.
4.
5.
6.
O
N
O
F
F
The screws are conveniently
located in the cellophane
package in the accessory box
The Basics: How Your PowerSteamer Works
O
N
O
FF
ON
OFF
Power Switch
2.
3.
4.
5.
SmartMix
®
Tank
7.
ug310-5926_1697_1205.indd 5ug310-5926_1697_1205.indd 5 12/21/05 3:51:33 PM12/21/05 3:51:33 PM