Filter
Top Products
5. Fill tank with cool, fresh tap water. DO NOT fill with warm
water as this may cause leaking. Replace the cap on tank
FIRMLY. Follow step 5-6 in pre-operating instructions.
WARNING: DO NOT move the humidifier with water in the
tank or the humidifier base. The moving action of the water
may activate the water tank’s release nozzle and overfill the
humidifier base. This may cause the humidifier to function
intermittently, or stop emitting mist. Should this occur,
simply remove the excess water from the humidifier base.
IMPORTANT: If you do not plan to use your humidifier for
two or more days, make sure any residual water is drained
from the water tank and base to prevent any algae or
bacteria growth in stagnant water. Make sure the tank is dry.
CLEANING AND MAINTENANCE INSTRUCTIONS
Humidifiers provide comfort by adding moisture to dry,
heated indoor air. To benefit most from the humidifier and
avoid product misuse, follow all instructions carefully.
Please note that this is an electrical appliance and requires
attention when in use.
In addition, if you do not follow the recommended care and
maintenance guidelines, micro-organisms may be able to
grow in the water within the humidifier's tank. You must
routinely follow the cleaning procedures that follow in order
to ensure proper, efficient operation of your humidifier.
Proper maintenance and cleaning is essential to the
continued performance of your unit and the avoidance of
algae or bacteria build-up.
DAILY MAINTENANCE
1. Be sure the unit is OFF and is disconnected from the
electrical outlet
2. Remove the tank from the humidifier and place in sink
or tub.
3. Drain any remaining water and rinse thoroughly to
remove any sediment or dirt. Wipe clean and dry with a
clean cloth or paper towel.
4. Refill with cool tap water. Do not overfill.
WEEKLY MAINTENANCE
To Remove Scale:
1. Repeat steps 1-3 above.
2. Clean the base by partially filling
it with one 8-oz cups of undiluted
white vinegar or by using Cleanse
Clean
TM
Solution (DMS216) by the
manufacturer. Leave this solution
in the tank for 20 minutes, while
cleaning all interior surfaces with a
soft brush.
5
FREQUENTLY ASKED QUESTIONS
QUESTIONS
ANSWER
• What are the
variables that
affect run time?
The estimated run time for this
humidifier is based on average room
conditions. The actual run time of your
humidifier is dependent on numerous
variables such as:
1. Air exchange in the room where
the humidifier is placed.
2. Room construction where the
humidifier is placed.
3. Temperature of the room where
the humidifier is placed.
4. Humidity levels in the room where
the humidifier is placed.
5. Movement of occupants and the
opening and closing of doors in the
room where the humidifier is placed.
6. Home furnishings in the room
where the humidifier is placed.
• How do I
remove film on
water tank?
See Daily Maintenance instructions.
Regular cleaning is recommended.
• How can I
extend the
run time?
1. Run your unit on the lowest setting.
(not applicable to BU5200)
2. Fill the tank all the way full, place it
on the base, let the water empty
into the base until it stops bubbling,
then refill the tank full again. This
ensures maximum water capacity
and will extend run time.
6
Figure 2
Gently scrub the area around the transducer with a soft
brush. Remove the scale by wiping the entire base with
a cloth dampened with undiluted white vinegar.
3. Rinse clean with warm water to remove cleaning
solution before disinfecting the tank.
To Disinfect Tank
1. Fill humidifier tank 1/2 full with water and 1/2
tablespoon of chlorine bleach.
2. Let the solution stand for 20 minutes, swishing every
few minutes. Wet all surfaces.
3. Carefully empty the tank after 20 minutes, and rinse
with warm water until you can not detect any bleach
smell. Dry with a clean cloth or paper towel.
4. Refill the water tank as directed in Operating
Instructions, and turn the unit on.
BU5000_5100_5200-U_07EM2.qxd 7/23/07 13:49 Page 7