Filter
Top Products
the remote) To Unlock remote, hold down the mode
button for 2 seconds until the lock symbol disappears
from the screen. Once the remote is unlocked, press
the mode button again and the unit will quickly beep
5 times telling the user the signal was received.
DO NOT SYNC more than 1 unit at once. A
hazardous situation may occur.
Note: If the batteries are running low on power, a low
battery indicator will appear on the remote. Low batteries
will affect transmission distance and the screen contrast.
The manufacturer recommends replacing batteries
immediately.
Note: The maximum transmission distance for this remote
is 30 ft. Do not use remote more than 30 ft from appliance.
Remote must be used in same room as appliance.
Note: Galileo™ can be used in either Fahrenheit or
Celsius. To change the reading on the remote, flip the
remote over and push the button located on the right hand
side under the stand with a ball point pen tip. This switch
will change the reading from F to C and vice versa.
Note: Every minute while in Auto mode, the Galileo™
communicates with the base unit. If the Galileo™ goes
out of range and/or has low batteries, the communication
will stop, and after 8 minutes of non-communication the
unit will shut off.
MANUAL OPERATION WITH REMOTE
1. Press Mode button on the remote. "Low" illuminates
on remote screen indicating mode. The power light
on the unit will turn on. The unit turns on and operates
in "Low" mode. The units "Low" light will illuminate. In
this mode, the unit will continuously run at its low
wattage.
2. Press Mode button on remote a second time.
The remote screen will now display "High" (1500
Watts). The unit’s "High" light will illuminate and the
unit will run in this mode. In this mode the unit will
continuously run at 1500 Watts.
Note: While using the remote, the backlight function will
turn on when any button is pushed and will turn off after
10 seconds of non-use.
Note: Do not cover remote while in use, this may affect
the accuracy of the temperature reading.
Note: Do not place remote under lamps as the radiant
heat from the lamp may affect the accuracy of the
thermostat.
Note: Do not place remote on control panel while in use.
This may affect the temperature reading.
Note: Because heat rises, and the Galileo™ remote
senses temperature, Bionaire
®
recommends that you do
not locate the Galileo™ remote higher than 4ft from the
ground. By locating the Galileo™ more than 4ft from the
ground, you will get a less accurate temperature reading
than under normal circumstances.
THERMOSTAT OPERATION WITH REMOTE
1. Press Mode button on remote until the remote screen
displays "Auto" and "low". The "Set" temperature is
displayed next to the "Room" temp. The unit will cycle
on and off to maintain the "Set" temperature. The
default room temp = 72ºF/22ºC. In this mode the unit
will run to maintain the "Set" temperature.
2. Press Mode button on remote again. The remote
screen displays "Auto" and "high". The "Set"
temperature is displayed next to the "Room" temp.
The "Auto" light on unit stays illuminated. The unit will
cycle on and off to maintain the "Set" temperature at
high wattage (1500 Watts).
3. To turn unit "Off", press the Mode button and the LCD
will go blank (except for the "Room" temperature
display which is always displayed while batteries are in
the remote) and the unit will shut off.
Note: It is normal for the heater to cycle on and off as it
maintains the preset temperature. To prevent the unit from
4 5
mode
Figure 1
BCH3230U visual version.qxd 7/2/02 7:15 PM Page 8