Filter
Top Products
Finally, using your ionizer may result in an occasional
popping or cracking sound. This is a normal sound,
generally caused by a small build-up of ions that, when
discharged, cause the popping or cracking sound.
NOTE: It is important to replace the HEPA-Type filter at
the recommended intervals.
Using the ionizer in conjunction with dirty filters may result
in dirty particles exiting the air purifier and being attracted
to walls, carpets, furniture or other household objects.
These dirty particles may prove very difficult to remove.
Homes with excessive amounts of pet dander, dust, or
smoke may decrease the life expectancy of the HEPA-
Type filtration system and may interfere with the ionization
process. You may want to run the Ionizer less often and
check the condition of the HEPA-Type filter(s) more
frequently in order to reduce particles from being
attracted to surfaces throughout your home as
mentioned above.
PRE-OPERATING INSTRUCTIONS
1. Carefully unpack your Air Purifier. Select a firm, level
place where there are no obstructions to the air inlet
or filtered air outlet. A good location in a room is
approximately 1 foot away from the wall, in a central
location of your home.
2. Remove the air inlet grill by grasping the finger tabs on
both sides.
3. Remove the HEPA-Type filter by gripping on both
sides and pulling forward.
4. Remove protective plastic bag from the filter cartridge.
5. This model utilizes hang tabs and a filter clip. The clip
can only be attached to the tabs on the filter in only
one way. The filter clip should easily slide onto the
filter hang tab with only a small amount of pressure.
DO NOT use force while attaching the clip to the filter.
Align the clip on the top of the HEPA-Type filter with
the rails on the inside of the purifier unit. Gently slide
the filter onto the rail (Figure 1).
NOTE: The side with
the soft gasket should
face inward.
6. Replace air inlet grill
back onto unit securely.
DO NOT POINT OUTLET TOWARDS WALL.
AIR CLEANER SAFETY
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using appliance.
2. To avoid fire and shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. If the filter is covered by a bag when shipped: remove
plastic bag before use.
4. Keep the cord out of heavy traffic areas. To avoid fire
hazard NEVER put the cord under rugs, near heat
registers, radiators, stoves or heaters.
5. To protect against electrical hazards DO NOT immerse
in water or other liquids. Do not use near water.
6. Close supervision is necessary when any appliance is
used by, or near children or by disabled persons.
7. Always unplug the air purifeir before moving it,
opening the grill, changing the filters or whenever the
air purifier is not in use. Unplug by pulling on the plug
and not the cord.
8. NEVER drop or insert any object into any openings.
9. Do not operate any appliance with a damaged cord or
plug, if motor fan fails to rotate, after the appliance
malfunctions, or if it has been dropped or damaged in
any manner. Return appliance to manufacturer for
examination, electrical or mechanical adjustment or
repair.
10.Use appliance only for the intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
11.Do not use outdoors.
12.Never block the air openings, or place on soft surface,
such as bed or sofa, as this could cause the unit to
tip over thus blocking the air intake opening.
13.Keep unit away from heated surfaces and open
flames.
14.DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
the warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by qualified personnel only.
15.WARNING: To reduce the risk of fire or electrical
shock, DO NOT use this air purifier with any solid-
state speed control device.
16.DO NOT place anything on top of the unit.
PLEASE SAVE THESE
INSTRUCTIONS
CONSUMER SAFETY INFORMATION
THIS APPLIANCE HAS A POLARIZED
PLUG (one blade is wider than the other).
To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet
only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician
to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY.
The length of the cord used on this product was selected
to reduce the hazards of becoming tangled in, or tripping
over a longer cord. If a longer cord is necessary an
approved extension cord may be used. The electrical
rating of the extension cord must be equal to or greater
than the rating of the air cleaner (refer to the rating label
placed on the air purifier). Care must be taken to arrange
the extension cord where it cannot be pulled on by
children or accidentally tripped over.
IONIZER
Your Air Purifier has an independently controlled ionizer,
which, when turned on, releases negative ions into
outgoing filtered air. Ions are tiny particles that carry a
positive or negative charge. These ions exist naturally
around us, in the air, water and ground. Both positive and
negative ions are colorless, odorless and completely
harmless. Negative ions help the air purification process
by attaching themselves to very small airborne particles in
the room.
These particles take on a negative charge and may join
with positively charged particles such as dust, pollen,
smoke and pet dander to form larger particles that are
then more readily captured by the filter system, or may be
attracted to positively charged surfaces throughout the
home, like walls or floors. This may occur more frequently
when the filter is nearing the end of its functional life
expectancy and is able to capture less of the charged
particles.
You may also note after extended use, that dust has
collected around the grills or front panel. This is from the
ionization affect caused by the negative ions exiting from
the air outlet. This is additional evidence of the air
cleaning effectiveness of negative ions. The dust can be
easily removed with a clean, damp cloth or soft brush.
OPERATING INSTRUCTIONS
1. Plug into a 120V AC electrical outlet.
2. Select the desired operating speed. Air Purifiers have
three speed settings. You can select from HIGH ( ),
MEDIUM ( ) or LOW ( ) by moving the knob to the
desired setting.
3. To release negative ions into the filtered air, turn the
ionizer knob to ON ( ) and the light will illuminate.
4. For optimum air filtration, it is recommended to
operate the air purifier continuously. Its rugged motor
has been designed to give many years of use.
For continuous use, it is recommended to operate the air
purifier at the MEDIUM ( ) setting. For quieter operation
or use in a bedroom, select the LOW ( ) setting. When
high levels of air pollution are present, select the HIGH ( )
setting to quickly circulate and filter the room air.
Air Purifier
MODEL : BAP414-CN
Read instructions before operating.
Retain for future reference.
Instruction Leaflet
INFO-LINE
If after having read this leaflet, you have any
questions or comments on your air cleaner,
call 1-800-253-2764 in North America.
128311/9100040003400
☎
2 YEAR LIMITED WARRANTY
Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions or if in Canada, Sunbeam
Corporation (Canada) Limited doing business as Jarden
Consumer Solutions (collectively “JCS”) warrants that for
a period of two years from the date of purchase, this
product will be free from defects in material and
workmanship. JCS, at its option, will repair or replace this
product or any component of the product found to be
defective during the warranty period. Replacement will be
made with a new or remanufactured product or
component. If the product is no longer available,
replacement may be made with a similar product of equal
or greater value. This is your exclusive warranty. Do NOT
attempt to repair or adjust any electrical or mechanical
functions on this product. Doing so will void this warranty.
This warranty is valid for the original retail purchaser from
the date of initial retail purchase and is not transferable.
Keep the original sales receipt. Proof of purchase is
required to obtain warranty performance. JCS dealers,
service centers, or retail stores selling JCS products do
not have the right to alter, modify or any way change the
terms and conditions of this warranty.
This warranty does not cover normal wear of parts or
damage resulting from any of the following: negligent use
or misuse of the product, use on improper voltage or
current, use contrary to the operating instructions,
disassembly, repair or alteration by anyone other than
JCS or an authorized JCS service center. Further, the
warranty does not cover: Acts of God, such as fire, flood,
hurricanes and tornadoes.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential
damages caused by the breach of any express, implied
or statutory warranty or condition.
Except to the extent prohibited by applicable law, any
implied warranty or condition of merchantability or fitness
for a particular purpose is limited in duration to the
duration of the above warranty.
JCS disclaims all other warranties, conditions or
representations, express, implied, statutory or otherwise.
JCS shall not be liable for any damages of any kind
resulting from the purchase, use or misuse of, or inability
to use the product including incidental, special,
consequential or similar damages or loss of profits, or for
any breach of contract, fundamental or otherwise, or for
any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the
exclusion or limitation of incidental or consequential
damages or limitations on how long an implied warranty
lasts, so the above limitations or exclusion may not apply
to you.
This warranty gives you specific legal rights, and you may
also have other rights that vary from province to province,
state to state or jurisdiction to jurisdiction.
How to Obtain Warranty Service
In the U.S.A.
If you have any question regarding this warranty or would
like to obtain warranty service, please call
1-800-253-2764 and a convenient service center
address will be provided to you.
In Canada
If you have any question regarding this warranty or would
like to obtain warranty service, please call
1-800-253-2764 and a convenient service center
address will be provided to you.
In the U.S.A., this warranty is offered by Sunbeam
Products, Inc. doing business Jarden Consumer
Solutions located in Boca Raton, Florida 33431. In
Canada, this warranty is offered by Sunbeam Corporation
(Canada) Limited doing business as Jarden Consumer
Solutions, located at 20 B Hereford Street, Brampton,
Ontario L6Y 0M1. If you have any other problem or claim
in connection with this product, please write our
Consumer Service Department.
PLEASE DO NOT RETURN THIS PRODUCT TO ANY
OF THESE ADDRESSES OR TO THE PLACE OF
PURCHASE.
© 2008 Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions. All Rights Reserved. Distributed by
Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions, Boca Raton, Florida 33431.
BAP414CN08EFM1 Printed in China
Figure 1
Filter Quantity
Needed
1
Filter #
BAPF30
Filter Description
HEPA-Type/Carbon
Air Purifier
Model #
BAP414-CN
Problem Solution
Unit will not operate Check to make sure unit is
properly plugged in.
Check to make sure the unit is
on by sliding or rotating the
power switch to the ON
position.
Decreased air flow Check the filter to see if it is in
good condition and if it needs
to be changed.
Check to ensure nothing is
blocking air inlet and filtered air
outlet.
TROUBLESHOOTING
Figure 2
B
C
E
A
F
G
D
A. Speed Control Knob
B. Ionizer Control Knob
C. Ionizer Indicator Light
D. Air Inlet Grill
E. Washable Foam
Pre-Filter
F. HEPA-Type Filter
G. Filtered Air Outlet
If you have any questions regarding your product or
would like to learn more about other Bionaire
®
products, please contact our Consumer Service
Department at 1-800-253-2764 or visit our website at
www.bionaire.com.
CLEANING INSTRUCTIONS
Turn off and unplug the unit before cleaning.
1. The outside of the air purifier can be cleaned with a
soft, damp cloth.
2. The air inlet grill can be removed and washed in warm
soapy water (not dishwasher safe). Dry before
replacing in the unit.
3. The air outlet grill can be cleaned of dust with a small,
soft brush.
WARNING: Do not allow moisture to come in contact
with the main housing of the air purifier.
FILTER REPLACEMENT INSTRUCTIONS
1. Every few weeks, check the condition of the filter.
2. Remove the air inlet grill. Remove and examine the
foam pre-filter. If it has collected a noticeable amount
of dust or lint, remove it from the inlet of the grill and
wash it in warm soapy water. Rinse and drip dry the
pre-filter thoroughly before replacing it into the inlet of
the grill.
3. Check the condition of the HEPA-Type filter. If the filter
is dirty, remove the used HEPA-Type cartridge and
properly dispose of it. Do NOT try to wash and re-use
the HEPA-Type filter. Replace with a new HEPA-Type
filter, removing the protective polybag before inserting
into the air purifier.
NOTE: The side with the soft gasket should face
inward.
4. Filter Life – Under normal conditions of continuous
use, the HEPA-Type filter will operate efficiently for 3-6
months.
Replacement filters are available from your local retailer or
by calling 1-800-253-2764.
BAP414-CN_08EFM1.qxd:BAP1242/1412/1422CN04EFM2.qxd 5/26/08 3:12 PM Page 1