Filter
Top Products
Part No 840186 10 Form No F030409A
MV650H PUSH Vacuum Owner’s Manual
ASSEMBLY INSTRUCTIONS
Your BILLY GOAT
®
MV Vacuum was shipped in one carton, completely assembled except for the Hood/Upper
Handle Assembly. Mounting hardware for the Hood/Upper Handle Assembly is temporarily installed on the lower
handle and the Housing assembly.
READ all safety instructions before assembling unit.
TAKE CAUTION when removing the unit from the box the Hood/Upper Handle Assembly is
attached to the unit by cables.
Remove unit from carton. Make sure the following items that have been packed with unit:
Parts bag P/N 840190
Owner’s Manual, P/N 840186
Declaration of Conformity, P/N 840204
Honda Engine Manual
Warranty Card, P/N 400972
Ty-Wraps (2 ea)
Hardware Bag P/N 840190
DISCONNECT spark plug wire before assembling unit.
1. Attach hood assembly to the housing then hold in
place during the step 2.
NOTE: BE SURE ALL CABLES ARE ROUTED ON
THE UNDERSIDE OF THE HOOD AND HOUSING.
2. Install item #170 center bolt first when aligned with a nut
on the housing.
3. Attach rest of hood assembly to the housing using
corresponding hardware.
NOTE: You will have to insert the bolt/washer from the
inside by reaching through the hood.
- Two 7/16” wrenches.
1st