Filter
Top Products
Part No 890033 Form No F062306A
9
KD Owner’s Manual
OPERATION
STORAGE
Never store engine indoors or in enclosed poorly ventilated areas with fuel in tank, where fuel fumes may reach
an open flame, spark or pilot light, as on a furnace, water heater, clothes dryer or other gas appliance.
If engine is to be unused for 30 days or more, prepare as follows:
Remove all gasoline from carburetor and fuel tank to prevent gum deposits from forming on these parts and
causing possible malfunction of engine. Drain fuel outdoors, into an approved container, away from open flame. Be
sure engine is cool. Do not smoke. Run engine until fuel tank is empty and engine runs out of gasoline.
Like all mechanical tools, reasonable care must be used when operating machine.
Inspect machine work area and machine before operating. Make sure that all operators of this
equipment are trained in general machine use and safety.
PUT OIL IN ENGINE BEFORE STARTING
STARTING
ENGINE
: See engine manufacturer’s instructions for type and amount of oil and gasoline used. Engine
must be level when checking and filling oil and gasoline.
ENGINE SPEED
: Controlled by throttle lever on the engine. Under normal conditions, operate at minimum
throttle to accomplish your current cleaning task.
FUEL VALVE
: Move fuel valve to "ON" position (when provided on engine).
CHOKE
: Located on engine and must be controlled manually.
PRIMER
: Push primer per engine instructions (B&S only).
THROTTLE
: Located on engine and must be controlled manually.
IF YOUR UNIT FAILS TO START
:
See Troubleshooting on page 12.
HANDLING & TRANSPORTING
:
This unit requires two people to lift it. With the handle in the folded position, lift holding the
lower handle and belt/shaft guard one on each side of the machine. Secure the machine in place
during transport. See page 3 for weight specifications
Never lift the machine while the engine is running.