Filter
Top Products
Part No 791098 Form No F070207A
10
DL Owner’s Manual
MOUNTING: Main unit
GENERAL: Unit must be securely mounted to a trailer, truck bed,
or other similar surface before use. Do not use this unit in a
freestanding position. Unit is not stable until it has been secured in
place.
Secure unit by bolting through the base of the unit and through the
mounting surface using 3/8" dia. bolts, with washers and locking
nuts (see fig. 1)
MOUNTING: Figure 2 illustrates the mounting position to the
trailer (Billy Goat Part no. 791133) available from your Billy Goat
dealer. The unit is only mounted one way.
MOUNTING: Exhaust elbow
Note: this process is easier with two people, one to support the
exhaust elbow and one to attach plates and hardware.
1) Remove the loose hardware from the clamp assembly so that
there are 4 separate pieces (two top plates and two bottom
plates).
2) Apply good quality grease to the top and bottom of the toothed
plate of the exhaust elbow (791114). Also grease top surface of
housing and bottom of clamp plates where the gear will rotate.
3) Place the exhaust elbow on the chute with the teeth of the
flange against the worm gear and the exhaust holes aligning.
4) Place the two bottom plates on the opposite edges beside the
elbow teeth aligning the holes.
5) Place the top plates on top of the lower plates aligning the
holes.
6) Secure the assembly with a plate half on top of the elbow
flange and a plate half on bottom of the housing flange using 6, 1"
carriage bolts and 6 lock nuts (removed hardware in step 1).
Fig. 1
Fig. 2
Typical on
both
sides
Step 1&2
Mount with
these holes
on both sides