Filter
Top Products
Part No 791098 Form No F070207A
9
DL Owner’s Manual
ASSEMBLY
OPERATION
1. SECURELY ATTACH unit to the bed of a truck or to a trailer, so that the exhaust discharges into an enclosed container.
NOTE: This unit must be securely mounted to the bed of a truck or to a trailer before operating.
2. ATTACH hose to housing intake, using hose clamp (item 22) making sure to place the safety switch under the clamp. Then place
the clamp (item 22) over around the end of the hose to be attached to housing. Slide the hose onto the housing intake and place the
shut off switch under the clamp. Make sure the shut off switch is pressed in or the vacuum will not start, and clamp the hose to the
intake.
3. ASSEMBLE nozzle handle (item 45), to nozzle (item 25), using screw (item 51), eye bolt (item 31), washers (item 66), washers
(item 68) and lock nuts (item 60).
4. ATTACH assembled nozzle to hose using hose clamp (item 26). Before tightening hose clamp, position nozzle handle upward
when hose is stretched to prevent twisting load on hose assembly during operation.
5. ATTACH the hose boom (item 9) by sliding the boom through the rings on the top of housing.
6. ASSEMBLE hose band (item 29) around hose and secure chain between flanges of the hose band using capscrew (item 63) and
lock nut (item 59) Repeat same steps on the other chain. (See ADJUSTING HOSE BOOM on page 11).
7. SECURELY ATTACH exhaust elbow (item 21) capturing both flanges inside the clamp, then firmly tighten the clamp, securing the
elbow to the housing (see MOUNTING on page 10).
8. INSTALL a standard 12 volt lawn and garden battery “U1” series (not included) with at least 240 cold cranking amps and a 40
amp hour rating by using battery bracket DL (item no. 70, hold down rods (item 71), washers (item 65), and lock nuts (item 59).
9. ATTACH red battery cable to + terminal and black battery cable to - terminal.
Like all mechanical tools, reasonable care must be used when operating machine.
Inspect machine work area and machine before operating. Make sure that all operators of this
equipment are trained in general machine use and safety.
PUT OIL IN ENGINE BEFORE STARTING
STARTING
SECURE LOADER OR MOUNT BEFORE STARTING
ENGINE: See engine manufacturer’s instructions for type and amount of oil and gasoline used. Engine must be level
when checking and filling oil and gasoline.
ENGINE SPEED: Controlled by throttle lever on the engine.
INTAKE HOSE: Hose mounting assembly must be properly attached to vac housing and safety switch must be engaged
before engine will start. Note: Any damage to the switch or wiring harness will prevent engine from starting.
THROTTLE: Move throttle control to fast position.
KEY SWITCH: Turn to start position until engine begins to fire, immediately release the key to the run position.
Note: Do not hold key in start position more than 10 seconds per attempt.
IF YOUR UNIT FAILS TO START: See Troubleshooting on page 13. Also see engine owner's manual.
HANDLING & TRANSPORTING:
HOSE: DO NOT drag the hose with vehicle.
Never lift the machine while the engine is running.
ALWAYS SECURE THE NOZZLE BEFORE TRANSPORTING UNIT