Filter
Top Products
Form No. S3279-206
Supersedes S3279-106
Page 12 of 12
BARD MANUFACTURING CO.
BRYAN, OHIO 43506
www.bardhvac.com
Due to our continuous product improvement
policy, all specifications subject to change
without notice.
Before purchasing this appliance, read important energy
cost and efficiency information available from your retailer.
1 HPC: High pressure control is auto reset. Always used with compressor control module (CCM) which is included. See note 3.
2 LPC: Low pressure control is auto reset. Always used with compressor control module (CCM) which is included. See note 3.
3 CCM: Compressor control module has adjustable 30-second to 5-minute delay-on-break timer (which also provides a delay-on-make equal to 10% of delay-
on-break setting). The module also provides the lockout feature (with 1 retry) for high and/or low pressure controls, and a 2-minute timed bypass for low
pressure control.
4 LAC: Low ambient control permits cooling operation down to 0°F.
5 ALR: The alarm relay has a set of normally open and normally closed dry contacts to provide the ability to signal a condition of shutdown on either high or
low pressure controls.
6 SK: Start kit can be used with all -A single phase models only. Is not used or available for -B or -C three phase models.
7 DDC: Incorporates 4 additional sensors: discharge air temperature, indoor blower airflow, compressor current, and dirty filter. These sensing devices
function to input analog data such as temperature, as well as digital data such as air flow, compressor status or filter status.
8 "V" control module should be ordered in conjunction with direct digital controller (DDC) model TCS22. Refer to DDC specification sheet S3280 for more
information.
1 Low ambient control is required with economizer for low temperature compressor operation.
2 For use only with “V” Control Module and TCS22 Controller.
seludoMlortnoCgninoitidnoCriA
llA
sledoM
SNOITPOLORTNOCELBALIAVA
CPH 1 CPL 2 MCC 3 CAL 4 RLA 5 KS 6 CDD 7
edoCdellatsnIyrotcaF traPdellatsnIdleiF
dradnatSdradnatSdradnatSdradnatSdradnatSJylnOyrotcaF
dradnatSdradnatSdradnatSdradnatSdradnatS
M
6
ylnOyrotcaF
dradnatSdradnatSdradnatSdradnatSdradnatS
V8 ylnOyrotcaF
snoitpOnoitalitneV
sledoM 52LW,42LW,81LW 73LW,03LW 07LW,06LW,84LW,24LW
noitpircseD
dellatsnIyrotcaF
.oNedoC
dellatsnIdleiF
.oNtraP
dellatsnIyrotcaF
.oNedoC
dellatsnIdleiF
.oNtraP
dellatsnIyrotcaF
.oNedoC
dellatsnIdleiF
.oNtraP
dradnatS-repmaDriAhserFcirtemoraBX2-DAFBX 3-DAFBX 5-DAFB
etalPffO-knalBB2-POBB3-POBB 5-POB
repmaDriAhserFdezirotoMM2-DAF
MM 3-DAFMM
5-DAFM
tsuahxE/wnruteRgnirpS-rotalitneVlaicremmoCV2-VRCV 3-SVRCV 5-SVRC
tsuahxE/wnruteRrewoP-rotalitneVla
icremmoC
------
P3-PVRCP 5-PVRC
gnitaludoMylluF-rezimonocE 1 EB2-MFIEEC3-MFIEEC5-MFIE
gnitaludoMylluF-rezimonocE 21 DA/NDA/NDA/N
MODEL NUMBER |
CONTROL MODULES
J - Standard on all models
VOLTS & PHASE |
A - 230/208/60/1
B - 230/208/60/3
C - 460/60/3
| COIL OPTIONS
X - Standard
1 - Phenolic Coated Evaporator
2 - Phenolic Coated Condenser
3 - Phenolic Coated Evaporator
and Condenser
| OUTLET OPTIONS
X - Front (Standard)
CAPACITY |
18 - 1½ Ton
24 - 2 Ton
25 - 2 Ton
30 - 2½ Ton
37 - 3 Ton
42 - 3½ Ton
48 - 4 Ton
60 - 5 Ton
70 - 6 Ton
WL 37 2 A 10 X X X X X J
NOTE: For 0 KW and circuit breakers (230/208 Volt) or toggle disconnects (460 Volt) applications, insert 0Z in the KW field of the model number.
Air Conditioning Wall-Mount Model Nomenclature
REVISION
KW
COLOR OPTIONS
X - Beige (Standard)
1 - White
2 - Mesa Tan
4
- Buckeye Gray
5 - Desert Brown
8 - Dark Bronze
VENTILATION OPTIONS
See Table Below
FILTER OPTIONS
X - 1 inch Disposable (Standard)
W - 1 inch Washable
P - 2 inch Pleated
Form No.
S3279
February, 2006
Supersedes S3279-106