Filter
Top Products
Manual 2100-348
Page 17
The suction line temperatures in table above are based
upon 80° F dry bulb / 67° F wet bulb (50% R.H.)
temperature and rated airflow across the evaporator
during cooling cycle.
REMOVAL OF FAN SHROUD
1. Disconnect all power to the unit.
2. Remove the screws holding both grilles, one on each
side of unit, and remove grilles.
3. Remove screws holding fan shroud to condenser and
bottom. Nine (9) screws.
4. Unwire condenser fan motor.
5. Slide complete motor, fan blade, and shroud assembly
out the left side of the unit.
6. Service motor/fan as needed.
7. Reverse steps to reinstall.
FIGURE 10
TROUBLESHOOTING
TABLE 5
ledoM
noisnemiD
A
N206AW57.1
REFRIGERANT CHARGE
The correct system R-22 charge is shown on the unit
rating plate. Optimum unit performance will occur with a
refrigerant charge resulting in a suction line temperature
(6” from compressor) as shown in Table 7.
TABLE 7
REFRIGERANT CHARGE
ledoM
detaR
wolfriA
DO59
erutarepmeT
DO28
erutarepmeT
206AW007155-3526-06
284AW055165-4576-56
TABLE 6
INDOOR BLOWER PERFORMANCE
CFM @ 230V
.P.S.E
HnI
2
O
N206AW
3206AW2206AW3284AW2284AW
deepShgiHdeepShgiHdeepShgiHdeepShgiH
yrD
lioC
teW
lioC
yrD
lioC
teW
lioC
yrD
lioC
teW
lioC
yrD
lioC
teW
lioC
0.
1.
2.
5771
5761
5751
0061
5251
5241
0581
5571
0071
5761
-0061
5251
0061
5251
5241
5251
5241
0531
0071
0061
5741
5261
5251
0041
TABLE 8
RATED CFM AND ESP
ledoM
detaR
MFCPSE
dednemmoceR
egnaRwolfriA
N206AW524102.05241-5771
j
3206AW524102.05241-5771
j
2206AW525102.05251-0581
k
3284AW053102.00531-0061
j
2284AW004102.00041-0071
k
j Rated CFM & ESP on High Speed tap with
14 x 28 return air filter grille
k Rated CFM & ESP on High Speed tap with
20 x 30 filter
FAN BLADE SETTING DIMENSIONS
Shown in Figure 10 is the correct fan blade setting
dimension for proper air delivery across the outdoor coil.
Any service work requiring removal or adjustment in the
fan and/or motor area will require that the dimensions
below be checked and blade adjusted in or out on the
motor shaft accordingly.