Filter
Top Products
Manual 2100-218
Page 17
REMOVAL OF FAN SHROUD
1. Disconnect all power to the unit.
2. Remove the screws holding both grilles, one on each
side of unit, and remove grilles.
3. Remove screws holding fan shroud to condenser and
bottom. Nine (9) screws.
FIGURE 10
FAN BLADE SETTING
TROUBLESHOOTING
The suction line temperatures in table above are based
upon
80° F dry bulb / 67° F wet bulb (50% R.H.) temperature
and rated airflow across the evaporator during cooling
cycle.
TABLE 6
REFRIGERANT CHARGE
ledoM
detaR
wolfriA
DO59
erutarepmeT
DO28
erutarepmeT
124AW004145-2566-46
284AW055165-4576-56
206AW007155-3526-06
4. Unwire condenser fan motor.
5. Slide complete motor, fan blade, and shroud assembly
out the left side of the unit.
6. Service motor/fan as needed.
7. Reverse steps to reinstall.
REFRIGERANT CHARGE
The correct system R-22 charge is shown on the unit
rating plate. Optimum unit performance will occur with a
refrigerant charge resulting in a suction line temperature
(6” from compressor) as shown in Table 6.
TABLE 7
INDOOR BLOWER PERFORMANCE
CFM @ 230V
.P.S.E
HnI
2
0
284AW,124AW206AW
V032woLV032hgiHV032woLV032hgiH
lioCyrDlioCteWlioCyrDlioCteWlioCyrDlioCteWlioCyrDlioCteW
0.
1.
2.
3.
4.
5.
0561
0551
0541
0531
0031
---
0061
0051
0041
0031
5711
---
5881
0771
5361
0051
0731
0521
0081
5661
0451
0041
5821
0511
0061
5251
0541
5731
0022
0012
0002
5781
5771
0561
0002
0091
0081
0071
0061
5741
TABLE 5
FAN BLADE DIMENSION
ledoM
noisnemiD
A
124AW
284AW
206AW
57.1
FAN BLADE SETTING DIMENSIONS
Shown in Figure 10 is the correct fan blade setting
dimension for proper air delivery across the outdoor coil.
Any service work requiring removal or adjustment in the
fan and/or motor area will require that the dimensions
below be checked and blade adjusted in or out on the
motor shaft accordingly.