Filter
Top Products
Manual 2100-192
Page 15
TROUBLESHOOTING
FAN BLADE SETTING DIMENSIONS
Shown in the drawing below are the correct fan blade
setting dimensions for proper air delivery across the
outdoor coil.
Any service work requiring removal or adjustment in the
fan and/or motor area will require that the dimensions
below be checked and blade adjusted in or out on the
motor shaft accordingly.
REMOVAL OF FAN SHROUD
1. Disconnect all power to unit.
2. Remove the screws holding both grills, one on each
side of unit, and remove grills.
3. Remove screws holding fan shroud to condenser and
bottom – 9 screws.
4. Unwire condenser fan motor.
5. Slide complete motor, fan blade, and shroud assembly
out the left side of the unit.
6. Service motor/fan as needed.
7. Reverse steps to reinstall.
REFRIGERANT CHARGE
The correct system R-22 charge is shown on the unit
rating plate. Optimum unit performance will occur with
a refrigerant charge resulting in a suction line
temperature (6 inches from compressor) as shown in
Table 8.
The suction line temperatures in Table 8 are based upon
80ºF dry bulb/67ºF wet bulb (50 percent R.H.)
temperature and rated airflow across the evaporator
during cooling cycle.
TABLE 9
INDOOR BLOWER PERFORMANCE
CFM AT 230 VOLTS
.P.S.E
HnI
2
O
163AW,103AW
deepShgiHdeepSwoL
lioCyrDlioCteWlioCyrDlioCteW
0.593,1513,1059539
1.043,1072,1039519
2.582,1091,1019588
3.502,1001,1558038
4.011,1000,1008557
5.500,1078------
FIGURE 10
FAN BLADE SETTING
TABLE 7
FAN BLADE DIMENSION
ledoMAnoisnemiD
103AW
163AW
52.1
TABLE 8
SUCTION LINE TEMPERATURES
ledoM
detaR
wolfriA
F°59
.pmeTDO
F°28
.pmeTDO
103AW001,175-5566-46
163AW001,195-7546-26
TABLE 10
RATED CFM AND ESP
1 Rated CFM and ESP on high speed tap
ledoM
1
detaR
MFC
1
detaR
PSE
dednemmoceR
egnaRwolfriA
103AW
163AW
000,1
001,1
04.
03.
003,1-039
053,1-039