Filter
Top Products
4
• Place a compression nut and ferrule over
the spout tube.
• Install the mounting angle. Tighten the
compression nut by hand, then finish
tightening with a wrench.
• Screw the hot and cold connection hoses
to the mounting angle.
• Place a compression nut and washer over
the shank end of one of the connection
hoses.
• Attach the hose to the outlet port on the
valve with the compression fitting. Tighten
with a wrench. Repeat with the other
connection hose.
• Install the supply hoses (not included) and
connect them to the stops.
• After the drain is installed, turn on the
water and check all connections for leaks.