Filter
Top Products
3
Installation
Flush the supplies thoroughly before
installation.
Install the metal washer and friction washer on
the valve. Push the valve up through the hole
in the mounting surface. Install the mounting
plate.
Rest the valve assembly on the mounting sur-
face. Tighten the screws.
Place the handle assembly over the valve with
the lever or cross in the desired off position.
Hold the lever or cross steady with one hand.
With the other hand, thread the escutcheon
down over the mounting plate.
Assemble the spout: Push the escutcheon
onto the bottom of the spout (1). Fasten the
retaining screws with a 5mm allen wrench (2).
Push the pull rod down through the spout.