Filter
Top Products
4
5
Assembly
1. Flush pipe lines thoroughly.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4. Connect the supply pipes to the supply valves:
hot-left; cold-right.
5. Connect the pop-up rod to the pop-up waste
assembly.
Large differences in pressure between the hot and
cold water supply should be balanced.
Technical Data
Operating pressure: max. 147 psi
Recommended operating press.: 14.7 - 72.5 psi
Test pressure: 232 psi
Hot water temperature: max. 176° F
Recommended hot water temp.: 149° F
Hole size in deck:
Minimum: 1 1/4"
Maximum: 1 5/8"
Spare parts (see page 3)
1 Handle for cold/hot water 37299XXX
2 Screw cover cold/hot water 96481XXX
3 Spout lav mixer 96521XXX
4 Aerator lav mixer 96336XXX
5 Stop unit 94149000
6 Lift rod 94006XXX
7 Lift rod extension 96617000
8 Fixation set 96016000
9 Tube 30622210
10 Spout bidet mixer 96522XXX
11 Aerator bidet mixer 94005XXX
XXX = Colors
000chrome
810satinox
®
Install the pop-up drain
• Remove the plunger assembly.
• Unscrew the drain outlet flange from the tee.
• Unscrew the tailpiece from the tee. Wrap
the threads with plumbers’ thread tape and
replace.
• Install the white, flexible sealing gasket to the
flange. Sit it in the sink outlet.
• From under the sink, install the black mack
gasket, white friction ring , and retainer nut to
the flange. Do not tighten the nut against the
bottom of the sink at this time.
• Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn the
drain assembly.
• Tighten the retainer nut.
• Sit the plunger assembly in the drain.
• Install the horizontal rod so that the end goes
through the loop in the bottom of the height
adjuster.
• Install and hand tighten the pivot ball nut.
• Attach the swivel connector to the end of the
horizontal rod.
• Attach the swivel connector to the end of the
vertical rod. Position as desired, and tighten
with a small, flathead screwdriver.
plunger
height adjuster
drain outlet flange
sealing gasket
mack gasket
retainer nut
tee
pivot ball nut
horizontal rod
swivel connector
friction ring