Filter
Top Products
3
Installation
Remove the caps from the plaster shields on the rough
valve (1).
Cut the plaster shields so that they extend 1/16” outside
the surface of the finished wall (2).
Remove the plug from the spout outlet using a 17 mm
socket wrench (1).
Install the valve slip coupling on one of the the valves (2).
Mark a point on the slip coupling 3/16” from the surface
of the finished wall. Cut the slip coupling at that point
(3).
Install the spindle extension (1).
Mark a point on the spindle extension 9/16” from the
surface of the finished wall. Cut the spindle extension at
that point (2).
Seal the wall around the plaster
shields with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.
2
1
3