Filter
Top Products
4
Installation
Flush the hot and cold supplies thoroughly before installing
this faucet. Damage to the cartridges due to debris is not
covered by the Hansgrohe limited lifetime warranty.
Place the faucet and the sealing washer in position on the
basin / bidet.
Slip the slide washer, metal washer and collar nut over the
threaded base and tighten the collar nut by hand.
Tighten the tensioning screws.
Connect the supply hoses to the stops with 3/8“
compression fittings (not included).
Install the pop-up drain (not included with model
16506XX1).
Turn on the water and check all connections for
leaks.
sealing washer
slide washer
metal washer
collar nut
tensioning screws
Caution:
Do not bend or twist
the supply hoses!