Filter
Top Products
4
Install the faucet
Remove the plastic washer, fiber washer, friction washer,
and mounting nut from the faucet.
If the mounting surface is thicker than 1 3/8”, or if there
is insufficient space, discard the plastic washer.
From below the mounting surface, install the plastic wash-
er (if using), fiber washer, and friction washer. Install the
mounting nut, but do not tighten it completely.
Inspect the placement of the faucet. Reposition if neces-
sary.
When satisifed, finish tightening the mounting nut.
Tighten the tensioning screws.
Connect the hoses to the stops using 3/8” compression
fittings (not included). Use two wrenches, as shown in
the diagram, to prevent the hoses from twisting or from
becoming loosened from the faucet.
For proper operation of the faucet, the hot supply should
be on the left, and the cold supply should be on the right.
fiber washer
friction washer
mounting nut
tensioning
screws
fiber washer
friction washer
mounting nut
tensioning
screws
plastic washer