Filter
Top Products
4
5
Assembly
1. Flush pipe lines thoroughly.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand.
4. Tighten screws.
5. Connect the supply pipes to the supply valves:
hot-left; cold-right.
6. Connect the lift rod to the pop-up waste
assembly (only 10030XX1, 10050XX1 and
10230XX1).
The hot and cold supplies must be of equal
pressures.
Mounting
Hole size in deck:
Minimum: 1 1/4"
Maximum: 1 5/8"
Technical data
Operating pressure: max. 147 psi
Recommended operating press.: 14.7 - 72.5 psi
Test pressure: 232 psi
Hot water temperature: max. 176° F
Recommended hot water temp.: 149° F
max. 1"
hot
warm