Filter
Top Products
7
Installation 06596XX0
Mark the positions of the screw holes.
Drill the screw holes using a 6 mm bit suitable for
the wall surface.
Install the anchors.
Screw the support into the anchors. The pin on
the support should be on the bottom.
Slide the cover over the support. The pin on the
support clicks into place in the hole in the cover.
Place the accessory into the holder.
The accessory may be removed from the holder.
Screw the support into the anchors.
Slide the toilet paper holder over the support.
If the accessory is installed in the
shower, seal the wall around the
anchors with waterproof sealant.
Failure to seal the wall can lead
to possible water damage.