Filter
Top Products
7
Install the Handshower Holder Escutcheon and
Handshower
Remove the plaster shield from the handshower holder.
Pull out on the handshower hose.
Screw the handshower holder escutcheon into place.
Install the elbow.
User Instructions
Turn the left handle to obtain hot water, the right handle to obtain cold water.
When the water is turned on, it will come through the spout. To obtain water from
the handshower, pull up on the diverter knob.
The diverter will reset to the spout position when the water is turned off.
Firmly press the spout over the tee and diverter.
Tighten the set screw with the included 3 mm
Allen wrench.
CAUTION: do not overtighten the set screw or
the o-rings on the diverter will deform, which
will cause a leak.
Install the pull rod. The threaded end of the
pull rod must go into the hole in the pin.
Place a black rubber hose washer in the elbow.
Screw the handshower into the elbow.
Guide the handshower into the holder.